|
Thanks for the starting point!
I'll plan on a good blowing out, look for bad solder joints, and clean the pots with deoxit.
Is there any way to see what flyback I have, and anything I can do to protect it as much as possible?
I'm not 100% sure, but if I was a betting man I'd say the flyback was either replaced or was worked on at some point. Its the only item on the board with dried up flux around the solder joints. There's not a trace anywhere buy the flyback.
Also, are there any repair manuals for this other than the Sams? If ai need one, ill get it, but if not even better.
Marc
|