|
I should add that the set does have separate G2 controls for red, green and blue. You adjust those in setup mode to equal intensity and then go back to normal mode and with a black and white image, you adjust the taps to remove any color in the white areas of the image.
I should add that I've tried the setup switch and it does not produce a bright enough line for any of them, so I did it with a pattern generator and adjusted to get the best white lines. It was then I used a black and white image to adjust the taps. Maybe not the best way to do it, but I've been unable to figure out why the setup isn't working. I cleaned the switch and and checked the circuit, but I'm just not finding it. The CRT is good and the image is bright, just can't use the internal setup for the setup line(s).
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|