View Single Post
  #49  
Old 01-30-2025, 04:37 AM
etype2's Avatar
etype2 etype2 is offline
VideoKarma Member
 
Join Date: Mar 2010
Location: Valley of the Sun, formerly Silicon Valley, formerly Packer Land.
Posts: 1,643
Update, January 29, 2025

(Full restoration from start to date or scroll to Update, January 29, 2025: https://visions4netjournal.com/vinta...-tv-page-twoa/ )

From Mike,

Greetiings once again. I have added ground wires to the necessary boards but no pictures on that. Not much to it really. I have moved to the high voltage cage to change several caps in the horizontal centering circuits. In the process, I found a number of issues that needed to be addressed in the focus circuit. There was an extra resistor installed that really should not be there. It wasn’t hurting the operation but it was poorly installed and had no purpose so I removed it. Also, there was a resistor missing in the voltage divider for the focus voltage. Seemingly, there was also an extra resistor going to nothing as well. I also removed that one. I used the terminals that were freed from that removal to install the missing 2 meg 2 watt resistor that should be there for the voltage divider. Not sure what all of that was about. ?????? I also discovered some poor wiring on the focus control. A “cold” solder joint that was obviously intermittent mechanically. I replaced all of the wiring on the focus control to original specs. I observed some wax leakage from the flyback and removed what was easy to remove.

The pictures are as follows.
Pix 1 Top of chassis with all boards rebuilt
Pix 2 Chassis bottom without the covers installed yet. (Later)
Pix 3 Focus control circuit with extra 56 K ohm resistor
Pix 4 H.V. Section before repairs
Pix 5 Wax from flyback transformer
Pix 6 Cold/poor solder joint on focus control
Pix 7 330 K ohm resistor not connected to anything with black focus crt wire mis-wired.
Pix 8 Chassis shot of flyback
Pix 9 Caps replaced, wiring corrected. Notice 1 Meg 2 W resistor added and black focus wire in defferent place
Pix 10 Focus control wiring repaired
Yet to do: The tuner needs attention and I have already started on that.
R.F. I.F. alignment.
AFPC alignment in chroma circuits
Chroma Bandpass alignment
Make extention for back cover
Make new wing bolts for yoke clamp
Whatever else I can think of. There must be more.

https://visions4netjournal.com/wp-co...s-rebuilt.jpeg

https://visions4netjournal.com/wp-co...ut-covers.jpeg

https://visions4netjournal.com/wp-co...-resistor.jpeg

https://visions4netjournal.com/wp-co...e-repairs.jpeg

https://visions4netjournal.com/wp-co...m-flyback.jpeg

https://visions4netjournal.com/wp-co...s-control.jpeg

https://visions4netjournal.com/wp-co...ted-to-it.jpeg

https://visions4netjournal.com/wp-co...t-flyback.jpeg

https://visions4netjournal.com/wp-co...lack-wire.jpeg

https://visions4netjournal.com/wp-co...-repaired.jpeg
__________________

Last edited by etype2; 01-30-2025 at 04:49 AM.
Reply With Quote