View Single Post
  #22  
Old 12-31-2024, 03:38 PM
cj_reha's Avatar
cj_reha cj_reha is offline
VideoKarma Member
 
Join Date: Aug 2019
Location: Virginia Beach, VA
Posts: 90
Quote:
Originally Posted by Electronic M View Post
Great work so far. I do see one thing I find concerning....That last pic of the lytic you're restuffing the leads between the old and new terminals are bare and look long enough that when assembled they could potentially short to each other or the can. If I were you I would desolder one end of each, slip some heat shrink over and resolder. It would suck if they shorted and took out something hard to replace.
Don't worry - the wires weren't soldered in place yet, I just ran them through the drilled holes for a photo. I only wrapped & soldered them once the lid was on top so there's no excess length and no chance for them to short on anything
__________________
When you lower your standards, you set a new standard!

ISO: Mitsubishi 6CT-338, Sony Chromatron 19C70/100, Yaou "Colornetron" GTC-9, etc...
Reply With Quote