View Single Post
  #59  
Old 12-06-2024, 05:12 PM
vol.2's Avatar
vol.2 vol.2 is offline
VideoKarma Member
 
Join Date: Feb 2023
Posts: 435
Quote:
Originally Posted by Alex KL-1 View Post
Perhaps the VPS10 have less gain, setted internally. If is possible to raise the gain without altering the bias (perhaps a divider from the local supply to ground). But not entirely promising, since the IC have internal emitter R. Better is to provide more gain in the preamp.
I took a couple of scope readings of the red cathode as a baseline, while viewing a color bars.

I started with VPS07T installed and got it as bright as possible with true black pedestal and no smearing caused by saturation of the amp.

The VPS07T was showing about 58Vpkpk with black slightly over 100V, and the whites at 45V.

Then I installed VPS10 and took the same measurement first without changing anything.

The VPS10 was showing about 48Vpkpk with the black at about 96V and the whites at about 50Vpkpk.

So at the same settings, the gain of the VPS10 swings a little lower, resulting in a lower voltage for black and higher peak voltage.

Then, I color balanced the monitor with VPS10 installed, and I was able to increase the swing all the way to 60Vpkpk, but to get it there, I have to peak the manual brightness control and lower the G2 such that the pedestal is still below the level of the VPS07T. It's not a huge difference, voltage-wise, but it seems to make a big difference in the overall brightness and the color linearity.

The final scope reading with the VPS10 tuned the best I can get it is about 97V for black, and 40V for whites. Any higher contrast than that and the colors start to clip and I get smearing.

So it seems that the black level (the pedestal) is about 6V lower for the VPS10 than the VPS07T, and that's what I'd have to find a way to shift.

Currently, the only thing I can do to shift the whole DC offset range is to lower the bias controls, but if I do that, then image smears at a much lower drive level. I think the output circuit is somehow designed to have the bias controls at the top of their travel, and the G2 is supposed to be set with the bias as high as possible. The Service Manual instructions state to do this, and it seems to be correct.

Aside from the Drive, Amp, and Bias sections, there is the preamp IC, but I don't have a datasheet for it, nor can I find one anywhere on the net. Its a CXA1209P, a Sony IC.

Perhaps the answer is to alter values to the blanking pins or something?

Reply With Quote