View Single Post
  #55  
Old 11-18-2024, 12:44 AM
vol.2's Avatar
vol.2 vol.2 is offline
VideoKarma Member
 
Join Date: Feb 2023
Posts: 435
Quote:
Originally Posted by zeno View Post
On the red problem it may be bad filtering on the @200 V supply for the
video outs. This is a common problem on all brands ! Symptoms are:
Left side normal, right side too brite.
Streaking.
Shading.
Jail bars.
Pix too bright.
Retrace lines in some or all of pix.
Looks like bad CRT
+ more I cant remember !
Poor px, just dont look right.Any combination of above.

Usually its a 4.7mfd or 10 mfd on the @200 V.
G-2 setting must be right also. Be sure you can extinguish or nearly so
the raster & have NO retrace lines.
Now back to the @200 V. On most the neg goes to GND. On some
the neg goes to the main B+ then there is another 'lytic neg to GRD.
That can cause width & jail bars, plus all the above.

I tested C421 (10uf on the 200V) when I did the whole set and it looked good, but maybe it's a sneaky failure?

In any case it was one of few that wasn't replaced. I guess I can try that.

One interesting thing I found is that the far right side of the raster has bright fringing on the edges when the G2 is on the edge of making the raster glow, and it seems that things get weird if I push the brightness past that point. It's a really fine line where I can just barely get the brightness up past a dead black background and the image gets a lot worse and there's weird (and irregular) bright fringing on the right edge.

If I keep the G2 at right around dead black, the fringing goes away and the picture cleans up a lot (meaning I can get more headroom out of the contrast with a sharper picture). After I got it to that point, I was able to use a colorimeter and software to create a color profile that gamma corrects the monitor, so now the white point is correct and the picture is ramping the brightness correctly across the board. Looks a whole lot better now than it has at all so far.




Quote:
Originally Posted by old_tv_nut View Post
If you turn up contrast just to where it does bleed, and then turn brightness way down, does it go away?
No, the brightness doesn't seem to have an effect on the red ghosting/bleeding.

Quote:
I don't know, but it's possible it has a beam current limiter that works to turn down contrast as you turn up brightness, and that's why the brightness can't cause smearing. Or it could be something else peculiar to this chassis that I can't think of.
That could be true. It's got an automatic contrast control knob that I am supposed to set in the white balance procedure. It wants me to start off with everything super maxxed out and then use the contrast limiter to adjust it down. But this doesn't seem to work out when I follow what they want me to do. It seems to look much better when I ignore the brightness limiter and just turn the G2 down and the sub contrast down until everything is reasonable.

Quote:
]Anyway, the red smearing is most often an indication that the red video output stage is saturating (going to the lowest possible output voltage), often due to the setup voltages required with a tired tube.
It might be that, but also I might just be hitting some limits and it's a combination of things. As it stands now, it is plenty bright to use. I'm mostly now just concerned with the weird bright fringing on the right side of the screen. It might be worth replacing that 10uf cap on the 200V that measured good just in case.

Last edited by vol.2; 11-18-2024 at 12:48 AM.
Reply With Quote
Audiokarma