|
I just recently replaced all of the electrolytics on all of the boards that tested bad according to my ESR Meter, and the ones that were still good I left alone, and as far as the non-polarized caps went I left them alone because they were all orange or red drops (mylars) and I still can't get the picture to fill out and lock in vertically, it either bounces, rolls vertically or has lines going across the screen horizontally, no matter what I do I can't get the picture to fill out vertically like it should and I can't get the vertical lock in in the center of the vertical hold control it will only lock in at the extreme left setting of the vertical hold control and even then it still has a bounce to it, I've checked the vertical oscillator and output tube (6LU8 tube) and it measures fine yet (I've tried 3 different tubes in it and all three tubes measured good on my tube tester yet, as they measure >90 on the emissions test.)
Also I checked the picture tube emissions and all three color guns measured well above the the middle marking on the tester gauge (yes I did finally get a hold of a picture tube tester.)
Any ideas as to what else I could check, as I'm starting to run out of ideas as to what else I could check to get the picture to work like it should, because other than getting the vertical to lock and fill out I've pretty much got this TV working as it should.
|