[ieure]

Originally Posted by Electronic M

It's most likely in the resistors and caps between the plate of the sync separator and the vertical tube grids or possibly in the parts between the vertical output plate and the vertical osc grid. Resistors of this era tend to drift far higher than tolerance and caps can short, leak DC current or go open. If the tube was bad you'd probably have no deflection or little deflection... Though odd ball failures like a heater cathode short introducing AC could cause it. (Granted if it was a heater cathode short the set would loose sync strongly for an instant every ~11 seconds, assuming NTSC color vertical rate ,then relock on its own and continuously repeat the cycle).

Resistors you can check. Caps you can't properly check for leakage without an eye type capacitor tester that can perform leakage testing at full rated voltage...So substitution with new caps is usually the best test.

Thank you for the reply. I checked all the resistors from V2C down into the vertical oscillator and output stages (R170, R171, and R201-R215), and everything other than R209 looks good. That's the variable resistor which controls vertical linearity. The manual says it's a 2MΩ part, but mine peaks around 500kΩ. The image does exhibit non-linearity (the top of the image is compressed), but since this is a very cheap set and I haven't worked on a similar one, I'm not sure if that's a symptom of my problem, or just how these models are. The vertical hold, linearity, and size pots all seems to influence each other -- if I increase the size or change the linearity, the speed of the image roll changes.

I used some contact cleaner on the pots, and R209 improved, going up to around 1MΩ. Unfortunately, this made the overall problem worse -- the roll is much faster, and while I could get it to roll slow enough to show a clear image, I no longer can. Not sure what to make of that. This does at least track with my feeling of things being age-related. This set sat in a warehouse in Vancoucer, BC for decades, and while it looks very clean, I'm not surprised that some stuff may have oxidized.

I checked the caps in that area, and they don't seem to be short, at least. I'll put together a parts order with what I need and hope that helps.

Originally Posted by Electronic M

If you can make it roll up or down it's almost certainly a sync issue. Horizontal locking range will also tell you something about where the issue is...If horizontal hold is stable for almost a whole turn then it's the components between the separator plate and the vertical, but if hold just barely stably locks the whole sync separator stage, its tube, the components that feed it video and the level of that video become suspects.

Horizontal sync seems normal, and I have a large range where it'll lock hsync.

The schematic for this set seems to call the separator a "sync clipper" -- is that what they call the sync separator?