Yesterday I made some good progress!
I read more about the "How to change an Option Byte" in the service manual and then I compared what this model should have. Turns out, they were wrong!
Code:
Current Options Byte parameters
OP1 - 4
OP2 - 196
OP3 - 0
OP4 - 8
OP5 - 240
OP6 - 0
OP7 - 67
What the 28PT44060/01 model should have:
OP1 - 4
OP2 - 196
OP3 - 224
OP4 - 40
OP5 - 228
OP6 - 0
OP7 - 67
... and voilá! I now have the EW parameters available.
I guess this is a method to enable features that comes with the model/type of chassie in each model?
Anyway, this means that somehow/someone must have accidently changed these parameters when fiddling around in the service menu. I know I didn't!
I can now expand the picture and reduce the pincushion and finally adjust to a good looking geometry!
Super thanks to
@Alex KL-1 for all your support and help! The part where you mentioned that 7200 was controlled from the TDA95XX, that was the moment I started to read more about the Option Bytes.
Thank you for that!