Quote:
Originally Posted by Claustrofob
According to the service manual on page 68, panorama is only for 16:9 sets. This is a 4:3. And I don't have that circuit on the chassie of this model.
There's no parabola parameters either in the service menu of this model. I can show you later what I have.
I've checked all parts in the EW circuit and they all checks fine but will check again.
The last thing to check is everything in series with the yoke, I guess.
I noticed yesterday that L3 is very unstable, jumps from 130-150 V back and forth. I don’t know if that’s normal?
|
Is good to not take any measurements from L3 test point, since it can have up 1500V of peak voltage (the retrace interval), so it plays havoc or destroy meters.
The E-W MOSFET is feed from µC as show in the schematic?
Since you have schema, also not hurts if you play a little with the R values near the E-W MOSFET. Any bad progress and you can revert to original.