View Single Post
  #10  
Old 06-06-2024, 09:54 AM
Aperna1985 Aperna1985 is offline
VideoKarma Member
 
Join Date: Feb 2018
Posts: 187
Quote:
Originally Posted by Electronic M View Post
If you happen to have an audio generator or a low frequency RF generator with several volts of output you could that as a signal generator. It won't put out a standard pattern but you'll get black and white patches (whether they form spots or bars depends on the instantaneous frequency difference between them and the sweep). Hell, if the set isn't hot chassis you could capacitively couple 6.3v from the heater into the video amp grid....if the hum bar gets through you know that the amp is passing signal.
There's no perfect substitute for the right test equipment but if you're smart and desperate enough there's often some workable options.
Quote:
Originally Posted by Yamamaya42 View Post
Work in sections, you know you have HV, sweep, V+H, but going on that you had no results putting in a singal at point C, and going on the assumption that signal was good, and put in correctly, there should have been a reaction if the circuit was working from point C to the CRT, so there must be a fault.
In order to input a signal at the CRT, you need a negative signal at 50v PtP, only a few video equipment can do that, so it's best to work from the lower end and check things over.


I do have a BK1077B that I just restored, I'm just a little nervous about blowing it up. I was reading in the manual that it has a negative signal generator, would that put out enough? I was using the Heathkit because it's a little more disposable....
Reply With Quote
Audiokarma