View Single Post
  #8  
Old 06-05-2024, 03:04 PM
Yamamaya42's Avatar
Yamamaya42 Yamamaya42 is offline
VideoKarma Member
 
Join Date: Nov 2018
Location: Round Rock TX
Posts: 3,253
Work in sections, you know you have HV, sweep, V+H, but going on that you had no results putting in a singal at point C, and going on the assumption that signal was good, and put in correctly, there should have been a reaction if the circuit was working from point C to the CRT, so there must be a fault.
In order to input a signal at the CRT, you need a negative signal at 50v PtP, only a few video equipment can do that, so it's best to work from the lower end and check things over.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
Reply With Quote