|
The tv is nearing its first test, TV is mostly reassembled now but a few issues. One is concerning the CRT tube pins, they are bent because when I got this tv the plastic guide piece that normally is at the end of the neck holding the pins straight is broken and most of all of the plastic piece is long gone.
CRT tube socket that plugs into it has one of the wires pulled out and the end of it is a metal clip like connector thing. Basically looks like a lead. How do I put that back into the CRT tube socket? Can I solder it back into the CRT tube socket?
Also as happened with the Ford Philco tv, the zenith tv's CRT anode metal clip broke off the wire due to metal fatigue and corrosion.
Next realization I made was that out of the three IF tubes. The first two should be 6EH7s which they are....but the third IF stage tube should be 6EJ7 according to the photofact, parts list, and schematic but the tube in that socket was also a 6EH7...? Not sure if this was done in the factory or by a repairman or the prior owner at some point. From what I can understand a 6EH7 is inferior to 6EJ7 in terms of what it can handle performance wise despite having the same filament voltage and pinout of course. Either the photofact is wrong, the factory goofed up (I doubt it), or someone replaced it with the wrong tube?
Anyways getting all the wires plugged back in was surprisingly easy despite how many wires there are. The chassis and tuner often labeled what went where plus I took a ton of photos early on.
What is surprising to me though is how there are barely any cataracts on the crt TV at all....despite the TV showing all the signs of high hour use.
|