Quote:
Originally Posted by zeno
Ditto
I only saw it on the portables but first thing to check. Basically it
put 200+ volts on the 24 V line. Things explode !
Rolling may be from the AGC oops. If the tuner is SS there may be 2
controls. IF AGC & RF AGC.
Zeno 
|
The tuner on this TV is Solid state according to the tube & transistor placement chart on the back of the TV.
The AGC adjustment that I accidentally diddled was the one that was next to the Vertical Linearity and Height Adjustments, which I was trying to adjust those because of the vertical roll that I couldn't lock in, and the AGC flub caused the picture to do some sort of weird thing where the picture looked like a red and blue candycane stripe going down the screen with some other strange screen distortions mixed in.
The 2 watt resistors you were talking about aren't burnt to a crisp or anything in my TV (they actually look like brand new yet) but they do measure a little low (around 10k-15k ohms rather than the 27k ohms that they should measure, but they don't measure in the hundreds of ohms range that you said they would measure if they were truly bad.)
As for trying to measure whether or not the transistors were bad or shorted, I don't have a transistor checker but I do have a DMM with a diode check mode but the transistors are so small and have such small leads that none of my test probes or aligator clip adaptors for my DMM test probes will fit onto the transistor leads without touching each other.
Do you have any suggestions as to a way to test these transistors without either damaging them or having to spend a whole lot of money on an expensive transistor tester?
I know the $5 Harbor Freight Special DMM had a dedicated transistor tester section but I'm not sure how accurate it is as I've never had a chance to use that function on one of those before (I did have one of those $5 Harbor Freight Special DMMs that I picked up NOS at Goodwill once but it broke on me before I had a chance to extensively try out all of the features on it.)