Wow! Ok Apparently It must have been a leaky capacitor. I replaced the capacitor on the CRT driver board and the small electrolytic capacitor on the pincushion circuit control board. I also used deoxit and cleaned the two pots on the pincushion board for the vertical and horizontal. I believe one of the pots even had some tin whiskers which I wiped off and blew out the others with some compressed air.
I tried to rotate the pots a bit to get them loosened and cleaned and tried to put them back where they were. They likely still have drifted a bit for sure and will need more adjustments later.
Put the old 6GH8A tube in as well before turning on just out of curiosity. Finally also replaced one of the carbon comp resistors in the horiz. osc. circuit and while it measured out of circuit as 6% off value when it should have been 5%, it is possible that value went up even more at operating temp.
Still amazing at how well the convergence is despite it not having been adjusted since 1980.
Now to fix the degausser and get it working again, then onto recapping remaining electrolytics and any other problem caps. Primarily the one in the FT1 circuit, an electrolytic on the conv. board. some caps in the tuning circuit ect. Cleaning tuner and pots of front controls as well.
Some photos showing the progression of the picture as the tv warmed up and from me adjusting controls.
https://imgur.com/a/wzbJ6sp