|
Update as of last night: Primary issue of the "triple image" still not gone but performance of the TV is notably improved in other areas. Also decided to leave the NOS RCA 6GH8A tube in and just hold onto the old weak motorola one for now. Used deoxit on ALL the vacuum tube sockets and any other connectors or pots I could reach.
Then tested all the tubes. Confirmed that the only weak tube was the old 6GH8A all other tubes emissions are good and compared with known good NOS tubes. Cleaned the tv a bit more just for fun and my own satisfaction.
After completely recapping and replaced all of the three can caps with new capacitors and replacing the two diodes with 2 NOS germanium 1N34As:
1. It started right up just fine with no signs of trouble after replacing the stuff mentioned.
2. Horizontal triple image issue still is there but not any worse off than before.
3. The CRT picture tube can get way brighter now! Like WAY brighter in response to the brightness control on the front! WOW
4. Colors appear more vivid and pop out so to speak which was unexpected.
5. Fine tuning neon lamp indicator suddenly came back to life and now is always lit red the whole time. Should go out when fine tuning is correct. I know how to adjust the responsiveness of it and will do so later.
6. CRT makes a more satisfying sound when turned off suggesting a more thorough discharge when being turned off.
Conclusion: I am going to finish replacing remaining old electrolytic and any other remaining paper oil caps as well in the tuning and convergence circuits and any where else. I am also going to investigate the degaussing circuit further as it is obvious to me that it is not working. Appears to be controlled by some sort of relay.
Degaussing loop itself i measuring at 8ohms. Resoldered the antenna leads going to back of tv for a more solid connection.
Next will check diodes more closely once more, as well as focusing on old carbon comp resistors i the horizontal oscillator and AGC circuits for any that might be out of value range tolerance wise.
Beginning to suspect an issue with resistors or perhaps even a coil somewhere.
|