View Single Post
  #190  
Old 04-26-2023, 04:55 PM
timmy's Avatar
timmy timmy is offline
VideoKarma Member
 
Join Date: Jan 2011
Location: Delaware ny
Posts: 3,719
Ok alarms off the ballast worked but I’m getting the same voltage as with the new ballast so Chris your ballast is ok so now there are only 4 places that take b+ 2 for the clipper 1 for the audio trans and 1 for the limiter so I will be looking at the clipper first because of what the screen is showing maybe the clipper tube is full on drawing down the b+ it’s been as low as 107v but the b++ is still around 280v the sound is good almost to say the audio trans is good. Chris the diodes you have here are good 1kv 3 amp. The horizontal is working but there is very limited vertical because the vertical hold don’t work at all I’ll be checking the pot and there are a few caps in the vertical that could be the cause here as I had to replace them in a few of of my sets. If you look at when the pic rolls slow there is a block separating top from bottom that moves as it rolls but it’s stuck just below the center of the screen won’t move with the pot.

Last edited by timmy; 04-26-2023 at 05:12 PM.
Reply With Quote
Audiokarma