|
All diodes have now been tested in circuit using both my multimeter and my capacitor wizard (the manual claimed it could find shorted or leaky diodes in circuit).
All diodes seem to be ok, no shorts, none are open, and all are behaving as they should on the multimeter including the two that the sams photofact said to check if horizontal frequency is off. So that now leaves tube V8 as the last thing the photofact suggests checking. This is a horizontal oscillator tube the voltage levels going through this tube are far lower than from other tubes such as the horizontal output. Would it be safe to measure at one of the pin on this tube? Max voltage going through this tube per the schematic is about 275 volts, other pins on tube have lower voltages.
Should I suspect this tube as possibly being weak? Obviously heater is ok as this is a series string set and I doubt any shorts since that would cause other electrical issues and symptoms. The tube is 6GH8A. I do not have this tube but supposedly I may have some tubes that can substitute for it and have the same pinout and heater voltage and current such as 6EA8. Is it OK to substitute 6GH8A with a known good 6EA8 for this circuit and application to rule out a bad tube?
|