Thread: Magnavox T931
View Single Post
  #53  
Old 01-15-2023, 10:35 PM
LukeSimon LukeSimon is offline
VideoKarma Member
 
Join Date: May 2021
Posts: 183
Quote:
Originally Posted by Electronic M View Post
The 6ME6 is listed as a valid replacement in the sub books, but I'd be tempted to try the correct 6JE6 specified.

Early in my TV repair days I ended up selling a RCA 9T246 because I couldn't get rid of bad horizontal non-linearity.... Somehow I never noticed that the original 6BG6 had been replaced with a 6DQ6 or similar later H output, and apparently according to the next owner that was basically all that was wrong with it.
This was great advice. I tried multiple horizontal output tubes, and while they all had the same minimum cathode current, 195mA, each tube had a different cathode current where it achieved its best horizontal linearity.


I tried two 6MJ6 tubes, which are the highest wattage rated tube that is compatible with the 6JE6A, and one achieved good horizontal linearity at 230mA. The other 6MJ6 topped out at 220mA and was not able to achieve good linearity.



I then tried a 6LQ6/6JE6C, and it was able to achieve great linearity at 215mA. It’s achieved horizontal linearity is even better than what the 6MJ6 was able to achieve at 230mA!



The Sams Photofacts and Darr’s “Horizontal Sweep Servicing Handbook” both say that color TV’s should first adjust the efficiency coil to minimum current, and then turn the core clockwise until best linearity, but without exceeding the TV’s max current spec.

I also made sure to calibrate my SECO HC8 in-circuit current meter using an accurate digital current meter.
Attached Images
File Type: jpg F9BE5AB3-AEBF-4335-902E-1451FF315D6E.jpg (76.0 KB, 79 views)
File Type: jpg FA629D27-026D-4D85-BC42-5985A54D9B4C.jpg (59.3 KB, 79 views)
File Type: jpg DFB9BFCB-44C2-4FAF-AB51-17D218A5653B.jpg (70.3 KB, 81 views)
Reply With Quote