View Single Post
  #11  
Old 12-20-2022, 09:16 PM
Mangie Mangie is offline
VideoKarma Member
 
Join Date: Dec 2022
Posts: 14
Well Fella's, got home from work a bit late, but I had to jump into it. Curiosity been pulling at me all day lol. But I think I am on to something here with yall's help and had to get an update out, even though I haven't finished with all the poking.

First I checked them big resistors in the back bottom right, they both seemed to be close to spec.

Next I pulled and cleaned the boards and connections and tighten down the pins a bit.
didnt see any cracks or bad solder, but I suppose it could be hidden or not well seen.

Tried plugging the set back in, still no HV. However I noticed some smoke coming from the horizontal board. circuit breaker isnt tripping for the record. Found resistor 801 was getting real hot, burning off that deoxit that got on it lol. well that just so happens to be close to the drive transistor Zeno is talking about, think iirc looking at the schematic, that its connected to the drive transistor it or real close. so I got voltage readings on it and the collector is at 103v and half what the schematic says on the emitter. so that is waaaay of the 74 volts.

So what would be next best thing to check if the osc/drive is out? How does one check the horizontal drive transformer to see if there is an issue with that.

Oh I dont like that wire-resistor mod much at all myself. I am hoping it was just a failed resistor on the board and this was someones quick and dirty way of fixing it. I am going to dig into that later once I get things working again and make that right.
Reply With Quote