|
No HV can be several things on these, but when there is no HV and the circuit breaker does not trip, the most common problems are a big 10W or 20W (can't remember) low resistance wirewound resistor that is located on the flat portion of the chassis, on the extreme right-hand side. I've had a few of these sets come to me, where the resistor had opened up at some point, and the service shop simply jumped it with a clip lead (I'm not suggesting that you do that, if the resistor is open).
Another thing that will kill HV is lack of horizontal drive out of the horizontal oscillator/driver module and I've also seen the horizontal driver transformer develop an open winding. IIRC, there is a small electrolytic capacitor from the emitter of the horizontal output transistor to ground and if this cap opens, it can cause the driver module and/or the horizontal output transistor to fail (if the HOT shorts, it will trip the circuit breaker).
Dirty module contacts and cracked solder connections on the module contacts are common. Clean all of the module contacts with contact cleaner and a brush (both on the chassis and on the boards themselves), and re-tension the contacts so they are making a firm connection.
HV triplers are also a very common failure, but when they go, they'll generally short and trip the circuit breaker. I've also seen cases where the tripler will short and take the flyback and HOT with it. Also, I've seen triplers crack and arc to the chassis.
In comparison to later Zenith sets, these CC2 sets are generally easy to troubleshoot, especially with the service manual.
|