Quote:
Originally Posted by zeno
1) set to service, the SW on the board.
2) adj the APC control o bars just slowly go by.
3) SW to normal, adj ACC control per manual.
If the IC's are in sockets get rid of the sockets but IIRC
the sockets were gone by G-line sets.
Watch out for dirty Chromatic switch also.
Or be lazy & just change the 9-86 ( -01 ? ). Still thousands of them around.
Many NOS.
73 Zeno  |
Thanks for the alignment tips!
oh! Didnt think of the Chromatic switch. I shall give that a good cleaning as well. Also looks like the IC's are not in sockets and soldered right in.
Took a quick look on the ebay and I didnt see anything Chromatic switch or the board. Is there a good place to find parts for these old Zenith's