|
For that you will have to do as SB suggested.
======
Also for L42 getting hot, you know each coil & Cap are a tuned circuit, If there is something
wrong, it may be peaking at a poor point and creating too much power.
All I can think of right now would be to check focus voltage as best you can.
Since the flyback was removed, it may be a good idea to try and see as best you
can that the pins that go where you think they go have the right resistance on
them as best as you can determine.
Take a picture, several pictures, of the flyback wiring, then disconnect all the wires,
measure the resistance of all the pins as you see them using both schematics, and
try and determine if it's wired correctly. You may also want to check resistance
from one isolated winding to another, This confirms no short between windings
and that they are wired correctly inside the transformer.... Since you have 2
Flyback transformers, you can compare between the two.....
My thinking is that since that flyback has pins that are tied to components and then
back to other parts of the flyback, that if a wire is not connected right, then voltage
may be fed to, or from one section out of phase, and causing problems, possibly
even heat on L42.
====
Mainly pins 1 & 5.
Others may be involved, but 1&5 hook directly to L42 & the focus coil, and must be unhooked to get a good reading, which SAMS says is .45 ohms, I think.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|