View Single Post
  #5  
Old 10-07-2022, 07:18 PM
liammc00's Avatar
liammc00 liammc00 is offline
real TVs have a CRT
 
Join Date: Jun 2018
Location: Belpre, Ohio
Posts: 270
It being a funai means the mode switch is probably dirty and you don't have to do any soldering work to get to it. You just need to unscrew the mechanism from the top and two screws from underneath the chassis. Then left up the chassis a little bit to get to the mode switch. Another thing that can cause trouble are the tape end sensors the can sometimes get cold solder joints. Funai VCRs from 1992 and newer are very poorly made in my opinion and when a VCR powers off it's normally do to with mechanism and on funai's always start with mode switch. There are YouTube videos on getting to the mode switch on funai VCRs from that time poried.

Last edited by liammc00; 10-07-2022 at 07:26 PM.
Reply With Quote
Audiokarma