View Single Post
  #7  
Old 10-01-2022, 11:30 AM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
Certainly possible. I have a Silvertone CTC-15 clone that would short it's damper and completely loose HV if the horizontal frequency went too far off...It blew at least 2 good tubes when I was working on it. That was the first color set I restored to working and it sat a few months with dead HV because until I borrowed the damper for another set I and discovered it had failed I didn't retest it because it tested good before I lost HV.
That same set later had a weak damper that would test great unless you held the test button down for like 30+ seconds to get it to slump. That weakness caused unusably low HV.
Some problems are spooky in that the failed component WON'T test bad unless subjected to conditions more extreme than the normal use case of the test equipment.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote