|
None of this makes any sense here, given on the info provided.
You are saying this.
If R93 is disconnected, 190v is no longer loaded, and you get HV, but it's not C66 or V10 cause you tried it w/o them in the line.
Odd.
Things to try.
Disconnect R93 from the 190v line and hook a 620k 1w resistor from the 190v line to gnd ( aprox R93 +R94).
If it's able to keep 190v up and get hv, then the resistors in the set may be bad, even if the meter says good.
Or C65 is leaking, the 190v line does not have the power for the plate on pin 8 of the 6hs8 if C65 is leaking and trying to power it.
Also this could be a combo of things.
What is the voltage in/out and across R215.
Here are all points 190v feeds.
1- V6 cathode p1 C61
2- V6 g3 p9 R90,R89
3- V10 g1 p7 R93,R94
4- V12 g2 p3 R124
5- V21 plate p1 / cathode p7 R168
6- pullup R160
7- V21 g1 p2 r169 r170
8- pullup r149
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|