View Single Post
  #14  
Old 06-06-2022, 09:11 PM
dtvmcdonald's Avatar
dtvmcdonald dtvmcdonald is offline
VideoKarma Member
 
Join Date: Nov 2012
Posts: 1,268
I did the above tests and found that the fixed vertical output cathode resistor,
supposedly 2.7K, was 4k. I fixed that. It turns out that did not help since the
sweet spot is 4k total for that resistor and the pot.

I finally decided to see if it was the tube, a 6K6. I have no other 6K6 but I have
a couple of 6F6 ones, which have almost identical curves. There was no difference.

So I decided to try other tubes. First I tried a 6L6 (metal). This gave a perfectly
linear scope trace and with a touch of adjustment a very nice almost perfect linearity. I then tried a 6V6 an its almost but not quite as good.

The 6K6 is a .4 amp filament, the 6V6 .45, and the 6L6 .9 amp.
Since the currest is adjustment limited, the plate dissipation is about the same
in all the tubes and way under ratings. I'l probably leave the 6V6 in it.

But since its triode connected, why did they not use a triode?

Last edited by dtvmcdonald; 06-06-2022 at 09:17 PM.
Reply With Quote