|
Ok so the fault isn't gone entirely. What I'm finding now is that after a bit of run time the Key B voltage is dropping from 3.2 at the micro to 2.5. I have eliminated the switch board as it is a separate board and you can just pull the connector. No change to the voltage. So the issue appears to be isolated to the signal board. I did check the 3.3V supply and it is rock solid. When you watch it on the scope it seems to jump from the 3.2 down to the 2.5 vs a slow drift. Not a lot of parts in the circuit so I should be able to narrow it down hopefully pretty quickly. I did confirm it stops responding to the remote when in this fault condition.
|