Hey made some progress today. I put the HV rectifier back in its place, and removed, cleaned pins, sockets, and re-seated the sweep tubes, and powered it up again, with a meter across C146. It rose to an indicated 460V (so adding the 400V B+, that would give 860V, just about the 875V Boost in the Sams) and I heard the HV come up for about 2 seconds, then the Boost started dropping down to an indicated 160V, again referenced to B+, where it pretty much stayed for a few minutes.
Click to embiggen:
I repeated the test a couple of times more and the HV never returned, and the Boost never rose above that indicated 160V. I'm going to let the set cool down completely and try again.
This is the behavior I saw on first power-up, and so I think the completely dead HV was an anomaly caused by removing the tubes and moving things around. Now that I know it can make HV I don't have to hassle with putting a yoke in my 1077, and can hopefully go on to troubleshoot the actual problem.
Another thing I noticed: the 400V B+ is low, about 360V. This 400V source goes only to the Boost filter, and is derived from the main B+ that goes through the vertical centering control. I'm not sure why that is, that control is also connected inline with the yoke and it seems to me there would be an awful lot of noise on that 400V line, no? Anyway unless the source of the 400V is pertinent to the problem at hand I'd prefer not to worry about the why for right now. I'm going to connect another meter to the 400V source at the cold power-up and see if it's normal before the boost starts dropping, that may help me figure out if this is due to excessive current draw or something else.
This set has two varistors, one off the grid of the HO tube and the other between Boost and the grid of the HV reg. Is it possible one of these could develop a thermal intermittent causing...something? My theory right now is that the dropping boost is a symptom of whatever is really going on, and that low B+ is probably a clue. I'm reading the articles I've found in old Photofact Reporters about this circuit but still don't have my head around it.
Anyway thanks again for the all the suggestions, help and encouragement. As a thank you, here is a picture of the PAL DuraModule where the 6GH8 ought to be. I'm wondering if this is "real" PAL or some kind of reverse-engineered faux-PAL.