View Single Post
  #4  
Old 11-25-2021, 07:48 PM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,918
G-2 usually abt 450 volts.If its high it gives your problem.
If G-2 control is on the FBT check for an unsoldered pin
under it.
If G-2 control on CRT socket check the high ohm resistors (over 1 meg )
on socket.

If G-2 OK check the 3 cathodes of CRT ( KR, KB & KG) Should be in range of abt 120-140 VDC. If very low thats the problem. Report back.

73 Zeno
LFOD !
Reply With Quote