|
I notice quite a few plastic parts which should be on the front panel, notably the escutcheon over the channel selector knob, are missing. This leads me to believe either they weren't attached very solidly to the panel in the first place, or else the TV is so old the parts just fell off and were lost (!) as the glue holding them to the panel dried up.
If this set was made in the early 1950s this is very likely. The adhesives used back then were probably (likely nowhere near, although they were the best available then) as good as the ones used today. These parts (if they can be found) can be reattached to the panel with a modern adhesive the likes of Super Glue. Be careful if you use this, however, as once the parts to be glued together or are attached to a surface the bond is almost certainly permanent. Do not, under any circumstances, get any of this glue on your hands, fingers, etc. as it is nearly impossible to remove, except by soaking the bonded parts in hot water.
__________________
Jeff, WB8NHV
Collecting, restoring and enjoying vintage Zenith radios since 2002
Zenith. Gone, but not forgotten.
|