[vortalexfan]

OK well I've been looking over at places like Mouser and Digikey to see if I could find the parts there I would need to make the probes to get this VTVM going and I'm not having much luck I was thinking I could try and convert the old Switchcraft mic jack to a BNC jack and use a couple of generic BNC test leads that I could rig one of them up with the 1 Meg resistor that was required for the DC Range and have one without the resistor for the AC and Ohms setting, they would of course be two separate cables that would be swapped out as needed, but all I'm finding as far as BNC test leads are ones that have the positive and negative (black and red clip leads) together on one test lead cable and I'm not finding anything that has just one clip lead on it (just the red clip lead).

Any ideas as to where I might find something like that?