View Single Post
  #9  
Old 08-20-2021, 10:01 AM
RJMiranda RJMiranda is offline
VideoKarma Member
 
Join Date: May 2015
Location: Havana, Cuba
Posts: 63
First, check your video connection

I would first try feeding any known video output into the VTR Video In connector. The fancy screen many DVD players show when turned on will work. Or just play a DVD/VHS. Use an RCA to PL-259 (Amphenol) cable to connect the DVD/VHS yellow output plug to the big Video In connector on the VTR, and a similar cable between the Video Out connector of the VTR and your TV-monitorīs RCA Video In.

Then, power on your VTR and press the REC button (the heads will start spinning, you donīt need to have a tape threaded). Also switch the "Input select" lever to "Line". If you can see the picture from the DVD/VHS on your screen, your connections are OK. (You may also want to try feeding some audio. Will need two separate RCA to miniplug cables for that.)

After checking that the video goes to the screen, unlock the REC button by just moving the mode selector on the VTR away from the "Stop" position and back. The REC button will pop up, the heads will stop turning, and you should see "snow" on your screen (if your TV/monitor doesnīt switch to blue screen, as Electronic M. says). But by now you know that the connections are OK, (and the electronics on the VTR look good too) and that the playback picture (if any) will go to your screen.

It may help demagnetizing the heads (fixed and rotary) and the tape guides also. Keep any tapes several feet away from the demagnetizer. And turn off the VTR before using the demagnetizer.
Reply With Quote