|
Its quite OK to use HV ceramic caps for the coupling to the deflection plates.
If using tthe rated voltage use three of the rated value in poarallel, if using twice the voltage, use just two.
I've done that and it works fine.
I have that type Sencore. Did you use the 68 volt setting on cutoff and the "scope" setting for type? I've
used that on electrostatic scope tubes, electrostatic TV tubes, as well as iconoscopes and an
image orthicon and it works fine for cutoff. Sometimes modestly low emission is OK. If a slight increase in filament voltage
gives good emission you'll be at least passable.
Last edited by dtvmcdonald; 03-06-2021 at 10:18 AM.
|