Thread: Resistor values
View Single Post
  #10  
Old 01-18-2021, 09:03 PM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
In most restos I replace resistors last and usually only do it if I'm seeing performance issues or outright malfunction....In that case the marked tolerance of the original part is usually a hard limit (I might tolerate an extra %1-3 if it's burried or connects to something delicate like a coil terminal. I might be more generous if I'm just indescriminantly checking resistors but that is usually my MO.
Marked tolerance varies by application and era. In the 20s and 30s %20 was the most common tolerance and %10 or tighter was for special or precision stuff. The 40s %10 was coming in to dominance, but many TVs had a few %5 in them in important areas. By the 70s %5 seemed to be the standard.
Always watch the original tolerance if you are checking everything for %10 including that one critical %5 that clocks in at 9 then you are missing issues.

I think I have found around 5-7 different Sam's errors (and I know of many more others have found) 2 of which caused me to make sets worse off than what I started with, forcing me to work extra hard to get back to normal. While that's only about %5 of the sets I've worked on, its still enough that I try to ensure that I'm not about to labor under a typo (or the more common undocumented production change) before I change something. The best mistake is the one you realize and stop your self from making before you do it.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4

Last edited by Electronic M; 01-19-2021 at 12:28 AM.
Reply With Quote
Audiokarma