|
UPDATE...
Was able to view the video clip you posted and it looks like a stability issue from the video amp section, the picture washes out during the rapid transition between the light & dark scenes and this would affect the vert sync and AGC, follow the line from pin-2 of V703 which is the AGC keying, as this shifts it also affects the cathodes of 1st & 2nd video IF stages causing them to shift and that causes the output of the video amp (V204) to shift, as the 1st video amp drops off the voltage to the AGC and this pushes the 1st & 2nd IF amp cathodes more positive and 'round it goes.
That 6MU8 video amp was a problem in these sets, as they age the picture washes out from lost gain, also make sure someone didn't swap the IF tubes around at some point in the past. V201 is 6JH6 and V202 is 6GM6, Ive seen them swapped before.
Finally don't overlook the RF modulator you're using to supply the signal with, many are poorly designed and the older tube sets were never very forgiving to begin with.
|