View Single Post
  #11  
Old 12-12-2020, 09:06 PM
Jeffhs's Avatar
Jeffhs Jeffhs is offline
<----Zenith C845
 
Join Date: Feb 2003
Location: Fairport Harbor, Ohio (near Lake Erie)
Posts: 4,035
Quote:
Originally Posted by old_tv_nut View Post
"almost certainly caused by horizontal sweep failure. This can occur in solid state televisions (b&w or color) because the horizontal sweep in SS sets has nothing (or very little) to do with the HV plant."

You mean caused by vertical sweep failure.

Also, the high voltage production is very much dependent on horizontal sweep working, even in SS sets.
Thanks much for the corrections. I did not realize solid-state TVs also depend on the horizontal sweep being in working order, as do tube-powered sets.

I am nothing short of amazed there are no safeguards against sweep failure in SS televisions; in fact, I strongly believe there should be some sort of protection scheme, even one as simple as a fuse, to shut down the entire sweep system (both sweeps) in the event of failure of either sweep circuit. There are (or were, before flat screens), after all, federally-required HV shutdown circuits which literally shut down the set's HV production in case anything went wrong with the HV regulator, or anything else associated with the CRT second-anode voltage. This was mandated by the X-ray scare at the time (1970s, IIRC), often caused by defects in the manufacture of the HV regulator tube (generally a 6BK4).
__________________
Jeff, WB8NHV

Collecting, restoring and enjoying vintage Zenith radios since 2002

Zenith. Gone, but not forgotten.

Last edited by Jeffhs; 12-12-2020 at 09:12 PM.
Reply With Quote