Quote:
Originally Posted by TvGuru87
Alright, so i replaced most of the capacitors on the board, now it turns on but there is just a horizontal line across the screen.
|
Did you solder the LA7838? It's in the back right corner of the chassis looking at it from behind the TV (flyback in the near right corner).
These *all* developed ringlets around the pins.
Every
Single
One.
If you resolder the IC and it's still no joy, you need to replace the LA7838, the 100uf cap, the 220uf cap, and a good chance the low ohm (like 1 ohm) from the 24V source off pin 2 of the flyback that feeds the vertical output circuit. If the 1 ohm is burned, check the diode connected to it and make sure it's not shorted.
John