|
Your comments are interesting as I am observing the same with the luma drive in my CTC5N or the deluxe chassis. I have noticed white crushing which I had earlier attributed to the CRT. It is a uniform crushing of white highlights. But if it was the CRT, would I have expected a differential crushing which would reveal a color cast depending upon color primary efficiencies? Instead I see a relative uniform white crush.
It is interesting the older design of the CTC5 employing background controls (essentially gun DC brightness shifters) and screen controls makes for challenging effort in getting the guns to track. I discovered in the book "Colour Television" by Carnt and Townsend (published 1961) that they make specific reference to the CTC5 design with the deluxe chassis X-Z demodulator. On page 244 the authors discuss that the X Z vectors are chosen so that the output of the (R'-Y), 0.8(G'-Y) and 0.6(B'-Y) match the phosphor efficiency drive ratios. I see that both the Super and Deluxe chassis share the same luma amplifier circuit even though the Super has R'-Y / G'-Y demodulation. The 'Y signal division to match these ratios are in the plate circuit of the 12BY7 video output tube. E.g. the two 910 ohm resistors in the divider chain. A simple voltage divider calculation reveals 1.0 Red, 0.8 Green and 0.6 Blue.
I mention this because later designs dispensed with background control by virtue of matching as closely as possible the the DC levels applied to the CRT cathodes and the introduction of gain controls to offset the variability of phosphor efficiency differences most likely with aging of the CRT.
To get the CTC5 to track over the full range of brightness control setting, I found that there is a range of interaction between the background and screen adjustment which may be taken advantage of to match gun- phosphor efficiencies. Following the procedure with color gain minimum to initially preset the background controls, the screen controls are adjusted at a near minimum bright control setting for greys near black. Advancing the brightness, if there is a color cast in the whites of say green, return to minimum brightness slightly reduce the green screen and advance green background to ensure grey near black and then advance the brightness and look again at the whites. In other words, the lowering the screen voltage on a particular gun reduces the guns gain slightly to help facilitate good tracking.
I have gone on to explain this at length to show the effort I have expended to get the set to produce a better picture. The problem remains of a relatively dim picture (looks fine in a darkened room). But if you were to advance the contrast and brightness, two things are noticable: first the whites tend to crush and second the DC level reference becomes widely variable. That is the black level shifts all over the place with changing luminance. To me this suggests a problem in the Y amplifier.
Your thoughts?
It is also reassuring that you said the picture was perhaps a little less dim with the later CRT!
|