Thread: Lincazer
View Single Post
  #9  
Old 09-18-2020, 01:26 PM
grimer's Avatar
grimer grimer is offline
VideoKarma Member
 
Join Date: Sep 2006
Location: Jim Thorpe,PA
Posts: 353
Quote:
Originally Posted by MadMan View Post
Grimer, the Chevy transmission, where the speedo cable comes out, that gear thing that turns the cable was superceded on later models with a speed sensor that will fit in the same spot. Something like this. But again, you may have to make a gateway module.

IIRC, the Lincoln would calculate the wheel speed from the transmission output speed sensor - I don't think it had an actual speedo sensor, not sure. I'd have to look it up. Also, it may want a digital pulse or a sine wave, idk.

1998 is a bit early for a car to read the wheel speed from the ABS. Possible, but it'd be very early for it.
Indeed, I have a aftermarket screw in speed sensor,the GM ECM reads speed no problem at all. So I do have a speed signal to work with.I just have to figure out what
type of signal the Ford ECM wants to see ( gateway module like you mentioned),and where to send that signal. I temporarily clamped the original Ford output shaft sensor right in front of the water pump pulley,
I was hoping the 4 bolts would simulate the 4 tabs on the Ford output shaft sensor ring. I get ac voltage/sine wave,but no reading on the speedo or the OBD2 scanner,that is when I thought the ABS system
might have something to with the speedo? I still have some mechanical stuff to do( My home-made driveshaft is a bit out of balance) I'm happy the A/C and heat work so well...lol
Thanks for the input MadMan

Last edited by grimer; 09-18-2020 at 01:42 PM.
Reply With Quote