View Single Post
  #59  
Old 09-02-2020, 02:04 PM
Yamamaya42's Avatar
Yamamaya42 Yamamaya42 is offline
VideoKarma Member
 
Join Date: Nov 2018
Location: Round Rock TX
Posts: 3,255
I intend to re-do the AGC KEYING area as well, especially C54, the .001 1kv that carries horz pulse to the AGC circuit from the fbt, even though it looks like it was replaced before, I do not trust it, this set spent countless years in a damp dirty barn, it had rust, cobwebs and roach castings in it, so far, 95% of every cap paper/ electrolytic, even some film ones replaced before, have been bad, but luckily it seems that only 10 to 15% of resistors are bad, mostly 1watt and above.

To give an example, at first, some of the pots were so rusty, that they would not turn before being sprayed down with deoxit before I could get them to turn

I have the 3900pf npo 5% caps ordered, should be here tomorrow, prob won't hurt much just to replace the bypass caps, & the “new” tubes mentioned are already on the way.
Will just have to see how it behaves.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
Reply With Quote