View Single Post
  #2  
Old 07-22-2020, 01:29 PM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
Quote:
Originally Posted by BandDirector View Post
The rivet did fail, and I tried to make a electric tape line wall so that the leads don't make contact with any metal. The lytic was a polarized 10 mfd 450 volt, so it was extremely high voltage, the spec calls for 8 mf at 10 volts. I have a 4.7 mf at 50 volts floating around.
Usually you can use a machine screw with a nut to replace the rivet. I'm assuming the cap was the high pass crossover for the tweeters, in which case it needs to be close to original micro-farads for the frequency roll-off to be correct. Voltage not so critical. But the large speaker should sound pretty decent by itself.

Last edited by Kevin Kuehn; 07-22-2020 at 01:33 PM.
Reply With Quote