Quote:
Originally Posted by BandDirector
Question:
I have learned a good bit in a short time, especially since I had to do the full recap.
Before I start trying to really adjust and try to solve these continuing problems, what I could do is test the chassis components following the service guide. Use/learn the oscope, vtvm, create test pads with apropriate resistors, adjust the tuner to the proper mc readings, the picture and sound circuits, make sure the waves are correct, etc.
Would that potentially solve future problems? To service the set the way it would have been, would that insight add more to my knowledge base?
|
If and to an extent tuner alignment require expensive calibrated equipment and a very large amount of time and patience to learn compared to all other TV servicing and if you get it wrong it can be impossible to get it back...Wait a few restos before contemplating alignment.
The one exception to the above is tuner oscillator adjustment (which should center fine-tuning on channel)....your set could benefit from that and you can usually do it without significantly affecting alignment....there are almost as many different TV tuner designs as there are chassis so you need to read the manual carefully to find the correct procedure and adjustment points. Count the turns you make so if you were adjusting the wrong thing you can get it close to where it was.
Most schematics list voltages at the tube sockets anything more than 30% away from documented is likely an indication of fault. Note these voltages skew with the wall voltage in your house so if the B+ is 10% off so will be everything else...I often plug my sets into a variac and adjust the input voltage for the highest B+ rail derived from the power transformer/rectifier to be exactly what the schematic says so I don't have to factor a B+ skew into determining what the tolerance is in the socket measurements.
If measuring voltages on a live set work with one hand in your pocket and avoid getting shocked... Safety first.
You can sometimes find socket resistance charts which can also be helpful.
Scope work is often unnecessary once a set is as far along as yours is, but if you want to play around with a scope and learn how to see waveforms you can. I generally use my scope for adjusting H osc waveforms, looking for hum or other pronounced non-random noise, and when I suspect a waveform in a circuit is badly wrong and want to know exactly how it's wrong to gain insight into what is happening.
One thing I like to do when it isn't safe or practical to reach a test point with the set running is to take a couple of leads with small alligator clips on both ends and use those to hook the meter up with the set off then switch on the set. You can also get tube socket extenders but they are expensive and don't always match a needed test point.
If tubes test good and capacitors are new but a stage is performing badly the next thing I usually suspect is out of tolerance resistors...some circuits with large adjustment range like vertical I try to adjust first before worrying about resistors....the vertical could have been adjusted to compensate for a bad tube or leaking capacitor that you changed and now needs readjustment for good parts.