Quote:
Originally Posted by fixmeplease
In post #67, the 2nd pic near the top where you replaced a bunch of caps. Between 5 new caps i think their is a bumblebee cap... possible its a resistor but I think its a cap. Your schematic will tell you which it is.
|
The pic was taken before I caught that, went back and replaced it and uploaded the old pic. I'm about to finish installing the second set of lytics, then going to see what happens!
I lack about 15 caps overall to finish the recap, but the original owner of this chassis said the low volt rect had a hard glow, so I want to check to see if new filter caps eases the pull on that plate.