|
It's probably electrically sound. Most caps have low enough current that non-stranded phone wire is thick enough (but phone wire usually doesn't have enough insulation voltage rating to be ideal).
I would recommend drilling a hold in the chassis and screwing (or soldering if your iron is rated 60W or more) the terminal strip down to the chassis rather than leaving the thing supported by just wires.
Caps smaller than your thumb usually can be safely supported by just their leads if connected to solidly mounted terminals. Caps bigger than that I often use cable ties (aka zip ties)...some hardware stores stock zip ties with a screw hole eye on the ratchet end...those you can snug down on a cap then screw the zip tie to the chassis.
There are other methods like restuffing the original lytics too.
What matters is that the right points are connected together and not shorted or prone to shorting and that it's all reasonably mechanically sound (not going to vibrate apart or break under likely conditions of storage and transport).
Leads are leads...caps with radial leads have the leads protruding from one side of the cap and on a round cap they are on different points on the radius this lead location style is called radial....Caps with axial leads have one lead coming from each end and those leads form an axis line (or you could say the cap looks like the axle on your truck if that floats yer boat) and that's why they are called axial lead caps.
Last edited by Electronic M; 07-15-2020 at 01:28 PM.
|