|
All of the new negative leads need to connect to the chassis electrically (assuming the old negative leads connected to the chassis), but it is OK to connect the negative lead of one capacitor to the chassis and then connect the remaining negative leads to the first negative lead. It doesn't matter which one you start with.
A positive lead must individually connect to the wires that went to the positive lead of the original capacitor, but must not connect to the original capacitor itself. You should end up with no wires connected to the old capacitor positive leads (or lugs). In other words, the old capacitor outer aluminum can or negative lead can remain connected, but its positive lead must be disconnected from the circuitry and not connect to anything.
This may require installing a terminal strip to provide isolated connection points for the new positive leads and the old associated wires.
If the old negative lead did not connect to the chassis, you need to provide an isolated terminal for the negative lead of the replacement as well as the positive lead.
__________________
www.bretl.com
Old TV literature, New York World's Fair, and other miscellany
Last edited by old_tv_nut; 07-14-2020 at 10:16 PM.
|