Quote:
Originally Posted by BandDirector
I am pretty sure a cracked flyback wheel won't make a crt jump up and shine, I think I made that happen trying to resolder the hv lead to the tube cap.
Oh well. Need to replace it. Now I can get over trying to just see it glow a bit and start the real work.
|
Most flybacks windings of that era were covered in wax or tar as insulation. NOS flybacks can have that insulation cracked too.
It is no big deal that the insulation cracked the flybacks will work with it cracked perfectly fine (assuming no other problems in the flyback or horizontal system)...the worst that that might happen as a result of the crack is Corona or arcing between that point and ground....you can fix the crack by GENTLY removing any loose wax/tar around it (if there is any) and then smearing a bit of sensor safe automotive RTV silicone over the crack/bald spot.
Some flybacks that have gotten hot in opperation have melted that wax/tar coating clean off and work without it.
The key thing with flybacks is that they aren't open (check winding resistance against that listed in the sams for your model to confirm it isn't open), and don't have shorted turns (that can be checked with a ring test, but most people don't bother unless there are troubles post recap).
TLDR: your flyback is probably just fine, silicone the crack and start recapping the chassis.