OK, Depression has passed

... After removing chassis and putting it on the stand I found absolutely nothing that I felt might have caused this minor setback. Hooked all back up and same horizontal bar across the screen. Messed with the 12 pin plug with no positive results. Then I noticed that one of the two LV rectifiers (5R4) on the PS chassis was glowing very dimly filament-wise. Removed it and reamed out the socket, bright filament and a full screen raster!!
Spent the day on the remaining sockets just to avoid further poor connection scenarios down the road.
Old Nut.. messed with the contrast control as per your suggestion, with no real noticeable video or audio effects...screen darkens up as contrast is increased, that's about all.
I was running the tuner through its paces and I found one position almost between chs 8&10 where I actually got some real off-air audio. Fine tuning had a major effect on volume of the noise. No real effect on the raster however. As I said, the contrast control really did not have an effect either.
I suppose that I should pull the tuner and give the switches a major going over in case they are suffering from this Gawd awful problem that every other connection point in this set seems to have.
Has anyone else ever seen a set suffering from this malady?