View Single Post
  #9  
Old 03-16-2020, 04:23 PM
BandDirector
Guest
 
Posts: n/a
Quote:
Originally Posted by old_coot88 View Post
You shouldn't be running AC to anything but black & red/black, nowhere else. That's the primary of the xfmr. Do this -

Remove all the tubes except the high voltage rectifier (probably 1B3)*. This removes all loads from the secondaries of the power xfmr. Now run AC to the primary (black & red/black) again. If the xfmr still smokes, it's shot.

*The 1B3's filament runs off the flyback.

It's shot. Smokeup and sizzle with no load and completely disconnected.
Reply With Quote