View Single Post
  #5  
Old 03-15-2020, 01:09 PM
JohnCT's Avatar
JohnCT JohnCT is offline
VideoKarma Member
 
Join Date: Jan 2020
Posts: 749
Quote:
Originally Posted by old_coot88 View Post
Others' opinions may vary, but here's my $.02 worth..

1. Service-wise, those early printed circuit layouts were the worst ever conceived, with the foil side of the boards made inaccessable (what were they smokin' to come up with that idea? Musta thought the design was bulletproof and would never need troubleshooting.
True. Don't have a clue what they were thinking other than having exceptional built-in shielding. I worked on a few when I was a young shaver, and my dad had me tack in the defective part on top of the board. Once the TV was running, he had me remove the circuit board and place the components as the factory did.

One good thing about it was that you had to use more technique than just shotgunning if you wanted a nice neat job. Later on, when RCA went to their "unitized" chassis (no more modules), the technique as described in the service manuals was to cut the defective part off the top of the board and solder a new one in place using the old leads. The reason is that RCA used a conformal coating on the bottom they did not want to be disturbed. I used to install those parts through the board despite RCA's admonition not to.


Quote:
Originally Posted by old_coot88 View Post
2. The newly-introduced small neck CRTs usually died an early death. Before proceeding any further, find someone with a CRT tester to verify that (if by some miracle) the CRT is good.
Another good point that I totally missed.

John
Reply With Quote
Audiokarma